Can't find the bullets you need? 


 Bullets molds may be available with suppliers or a custom mold can be made. 


OR, if you buy a mold, send it    to me to make your bullets and you keep the mold after.



"Quality means doing it right when no one is looking." Henry Ford

Copyright @ Jet Bullets. All rights reserved.

Jet Bullets is a registered trademark.

Cast Bullet FAQ and Shooting Tips


How fast can I shoot cast bullets without leading my bore?

   Rules of thumb:

  • Gas check hard cast bullet: 1700-2000 fps
  • Plain based hard cast bullet: 1200-1500 fps 
  • Plain based soft cast bullet: 800 - 1000 fps

   this is assuming a clean, good condition bore. Some rifles will do

   better, some not. Bore condition and bullet fit are the biggest factors.


Tips for Shooting Cast Bullets


1. Bore preparation: Before you start with cast bullets - leading can be prevented by giving the barrel a good scrub with copper and lead solvents before shooting cast.


2. Barrel Break-In: With a new rifle or barrel, break in the barrel with 20 or more jacketed bullets before shooting cast. After break-in with jacketed bullets, switch to cast and there will far less initial chance of lead fouling.


3. Cast Bullet Sizing: Cast bullets need to seal the bore well to prevent gas cutting, A cast bullet is normally .001-.002" larger than barrel groove diameter.


4. Barrel Condition: Barrels that have rough sections, excessive pitting, rust, or damage may suffer excessive lead fouling with cast bullets. Jacketed bullets are likely the best bet for these barrels.